This is a live case: the car is still in the workshop. We will update this page when the repair is done. Last updated .
- Car
- 2008 Bentley Continental GT
- In the workshop
- November 2026
- Updated
- Fault codes
- P2300, P2303, P2306, P2309, P2312, P2315, P0307, P0308, P0309, P0311, P0312
- Tools
- PicoScope, Wiring diagrams
The complaint
Misfires, sluggish pick-up, and the check engine light stays on.
What we have found so far
The scan showed six ignition coil faults, P2300, P2303, P2306, P2309, P2312 and P2315 (ignition coil A to F primary control circuit low), plus misfire codes concentrated on bank 2. Live data showed the misfire counters climbing on cylinders 7, 8, 9 and 10.
These are four-wire coils with a transistor inside each coil; the engine computer sends the control signal that fires them. We put the PicoScope on the coil wiring and found an elevated ground of almost 1 volt (1.008 V on the measurement ruler), where a good ground sits close to zero. We then scoped the other coils to see whether they showed the same thing.
That testing points to the ignition coil control circuits inside the engine computer (ECM).
Current finding
Not final yet. Testing so far shows the ignition coil control circuits in the engine computer (ECM) are not working correctly.
Next step
The ECM is being diagnosed further so it can be repaired rather than replaced. Nothing has been replaced so far.
Status
Live case. The car is still in the workshop while the ECM is checked. We will update this page with the repair and the result.